Topic:
CLEANING AND LUBRICATION
Discussion:
From Joel H. Blatt joelblatt@aol.com
CLEANING: Remove the grip and barrel from
the action. Tape over both sides of the small pin below the hammer pin
so it doesnt fall out. Put on safety glasses, hold the action upside down,
and spray CrudCutter, brake cleaner, or any other spray degreaser into
the action and into the safety channel just in front of the hammer. Let
it drip on newspaper and repeat until it runs clean. If you have a blued
action, be sure to use rust proofing stuff on the inside, since you have
just removed all rust preventing lubricant along with the crud. I would
suggest a rust proofing that isnt sticky and wont attract dirt and powder
residue. Your rust proofing doesnt have to lubricate - T/C recommends using
only graphite for lubrication. BE SURE TO LUBRICATE with graphite.
LUBRICATION: T/C recommends using no lubricants
other than graphite - use it sparingly. Cock the hammer and pay particular
attention to getting graphite into the safety block channel. Work the action,
trigger and hammer several times to spread the graphite around, then dump
any excess out on newspaper.
Disclaimer:
I am not responsible for the use or misuse of this
information.
I probably didn't even write this. These opinions are my own and are not
the opinions of my employer. He wouldn't write it either. |